Jumat, 15 April 2016
Dovetails Practice Practice Practice
So, I set out to cut a bunch of lines to get used to cutting on a straight line, but also cutting to my scribe line, or shoulder line. I took a slightly different approach though; see, when you practice something, you practice in the same way you would execute whatever it is you are practicing for. So, in that spirit, I decide to no just cut straight lines, but to practice the types of cuts you would make when doing dovetails, skewed cuts and angled cuts. So, with that, I grabbed a piece of 3/8" walnut, laid out a bunch of lines, and started cutting.
 |
| From Misc Woodworking |
Here you can see that, for the most part, I can cut a straight enough line; some on the left got a little crazy, but what I noticed is I need to do a better job of cutting to the line as on several of these, I went right past it.
This is a shot of the top of the practice board. Again, consistent angles all parallel to each other. These were laid out to simulate the types of cuts used when cutting the pins of a dovetail.
 |
| From Misc Woodworking |
Next I grabbed a piece of 3/8" mahogany and made a series of cuts that would simulate cutting the tails.
 |
| From Misc Woodworking |
Again, pretty consistent, but still room for improvement. My cutting to the line was much better on this one.
All-in-all, I think my cutting is pretty good. I definitely am going to do another round or two of practice cuts to get even more consistent; I also think I am going to practice cutting to save the line;personally, I think this is why mine just dont come out well. So, practice, practice, practice I shall do!
Be Safe!
